Range Rover Evoque: Isofix child seat positions
Isofix child seat positions
- IUF = Suitable for ISOFIX forward child restraint systems of universal category approved for use in the mass group.
- IL = These ISOFIX child restraint systems are of the specific vehicle, restricted or semi-universal categories.
- X = Not suitable for ISOFIX child restraint fitment in this mass group.
- * = Child seat suitable for use in these locations, is the Britax/Römer Baby Safe Plus
Note: Ages given are approximate. In case of doubt, the child’s weight, not age should be used when considering an appropriate child seat.
Note: The information contained in the table may not be applicable to all countries. If you are in any doubt regarding the type and fitment of child seats seek advice from your Dealer/ Authorised Repairer.
Note: ISOFIX anchorages are provided for second row outer seating positions. ISOFIX child restraints should be securely attached following the manufacturers instructions at these locations only.
READ NEXT:
Booster cushions
In a situation where a child is too large to fit
into a child safety seat but is still too small to
safely use just the three point belt, a booster
seat is recommended for maximum safety.
Follow t
Installing an isofix child seat
Installing an isofix child seat
To install an ISOFIX child seat:
1. Locate the ISOFIX locking mechanism.
2. Slide the child seat into the locking
mechanism.
3. If an upper tether is fitted to t
Tether anchorage points (Australia only)
WARNING:
Child restraint anchorages
are designed to withstand only those
loads imposed by correctly fitted child
restraints. Under no circumstances
are they to be used for adult seat
belts, ha
SEE MORE:
Rear Wheelhouse Outer
Removal
NOTES:
It is necessary to remove the inner quarter panel to enable removal and
installation of the rear wheelhouse outer.
The rear wheelhouse outer is manufactured from mild steel.
This method describes the LH rear wheelhouse outer, the RH side is similar.
1. The rear wheelhouse outer is
Rear Wheelhouse Front Extension
Removal
NOTE: The rear wheelhouse front extension is taken from the rear
wheelhouse outer and is manufactured from mild steel.
1. The rear wheelhouse outer is replaced in conjunction with:
Rear bumper cover
Quarter panel
Quarter glass
Front inner quarter panel
2. For additional information r
