Range Rover Evoque: Rolling re-start

If the engine is switched off while the vehicle is moving, a rolling re-start can be initiated.

Automatic transmission - select neutral (N) and then press the engine START/STOP button.

When the engine re-starts, select transmission position D.

Manual transmission - depress the clutch and then press the engine START/STOP button.

When the engine re-starts, select an appropriate forward gear.

READ NEXT:

 Keyless start backup

If the vehicle has been unlocked using the emergency key blade or the Smart Key is not detected by the vehicle, it will be necessary to use the keyless start backup to disarm the alarm and start t

 Stop/start (manual transmission only)

The Stop/Start system has been designed to improve fuel efficiency. The system is automatically activated when the ignition is switched on. When the engine has been stopped by the stop/start syst

 Conditions preventing automatic engine stop

The engine will not automatically stop if:<> - the external temperature is below approximately 0°C (32°F) - the external temperature is above approximately40°C (104°F) - engine has not re

SEE MORE:

 Rear Side Member Upper Side Extension

Removal NOTES: The rear side member upper side extension is manufactured from mild steel. If a new Rear side member upper side extension is being replaced in combination with a rear side member closing panel some MIG plug welds can be substituted for spot welds on installation within this procedu

 Event data recording

Event data recorders are capable of collecting and storing short sequences of data during a crash or near-crash event. The recorded information may assist in the investigation of such an event. The EDR may record information about vehicle dynamics and safety systems, potentially including such

© 2011-2025 Copyright www.rrevoque.org