Range Rover Evoque: Trailer levelling

To maintain vehicle stability, it is essential that the trailer is loaded so that it remains parallel to the ground. This is particularly important when towing twin axled trailers.

Vssential towing checks

READ NEXT:

 Trailer electrical connection

Connect only approved electrical circuits, which are in good condition, to the trailer socket. The vehicle connector provides a 5 amp output which must not be exceeded. An accessory harness ki

 Powered tailgate

When towing, ensure there is sufficient clearance before opening or closing the tailgate.

 Parking aids

The rear parking aids sensors are automatically disabled when a trailer with an approved electrical connector is connected. Note: Trailers fitted with LED lights will not disable the rear parking

SEE MORE:

 Programming

Programming With the engine switched off; 1. Ensure that the ignition system is on. 2. Hold the signal emitting end of the original garage door opener hand-held transmitter 50 to 150 mm (2 to 6 inches) away from the HomeLink transceiver in the rear-view mirror, keeping the indicator lamp in

 Floor Console Upper Section

Removal NOTE: Removal steps in this procedure may contain installation details. All vehicles 1. CAUTION: The procedure must be carried out on both sides. NOTE: LH illustration shown, RH is similar. Torque: 1.9 Nm Vehicles with manual transmission 2. Refer to: Gearshift Lever Knob (308-06 Manual Tr

© 2011-2025 Copyright www.rrevoque.org