Range Rover Evoque: Tyre care
Do not drive the vehicle if a
tyre is
damaged, excessively worn, or
incorrectly inflated.
Avoid contaminating the tyres with
vehicle fluids as they may cause
damage to the tyre.
Avoid spinning the wheels. The forces
released can damage the structure of
the tyre and cause it to fail.
If wheel spin is unavoidable due to a
loss of traction (in deep snow for
example), do not exceed the 50 km/h
(30 mph) point on the speedometer.
Note: Tyre condition should be checked after the vehicle has been used off-road. As soon as the vehicle returns to a normal, hard, road surface, stop and check for damage to the tyres.
All of the vehicle's tyres (including the spare) should be checked regularly for damage, wear and distortion. If you are in any doubt about the condition of a tyre, have it checked immediately by a tyre repair centre or your Land Rover Dealer/Authorised Repairer.
READ NEXT:
Tyre pressures
Never drive your vehicle if
the tyre
pressures are incorrect.
Pressure checks should only be
carried out when the tyres are cold,
and the vehicle has been stationary
for more than three hours.
Checking the tyre pressures
Tyre information label location.
Tyre pressures should be
checked
regularly using an accurate pressure
gauge, when the tyres are cold.
The following procedure should be used to
check and adj
Tyre valves
Keep the valve caps screwed down firmly to
prevent water or dirt entering the valve. Check
the valves for leaks when checking the tyre
pressures.
SEE MORE:
Using traction devices
Only use traction devices in
heavy
snow conditions, on hard road
surfaces.
Dynamic Stability Control (DSC) must
be switched off when using traction
devices.
Never exceed 50 km/h (30 mph) when
traction devices are fitted.
Never fit traction devices to a
temporary use spare wheel.
Land Ro
Fuel Pump
Removal
WARNING: This procedure involves fuel handling. Be prepared for fuel
spillage at all times and always observe fuel
handling precautions. Failure to follow these instructions may result in
personal injury.
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect
