Range Rover Evoque: Tyre change
Valve stem seal, washer, nut,
valve core
and cap should be replaced at every tyre
change. Valve stem seal, washer and
nut must be replaced if valve retention
nut is loosened. Sensor units and nuts
must be refitted using correct torque
figures and associated profile. Damage
to the vehicle may result if these
precautions are not taken.
Any tyre changes must be carried out by a qualified technician. Great care must be taken during removal and refitting of tyres to avoid damaging the sensor.
READ NEXT:
Replacement sensor
Should the sensor require replacing, it should
be carried out by a Dealer/Authorised Repairer.
A replacement sensor must be fitted to a
running wheel in order to be recognised by the
system. The v
Tyre repair kit
If you are in any doubt
regarding your
ability to carry out the instructions,
contact your Dealer/Approved
Repairer before attempting the repair.
Your vehicle may not be equipped with a spare
SEE MORE:
Parking Brake and Actuation
Parking Brake - Component Location
NOTE: RHD (right-hand drive) installation shown, LHD (left-hand drive)
installation similar.
COMPONENT LOCATION
ABS (anti-lock brake system) module
Instrument cluster
EPB (electronic parking brake) switch
RH (right-hand)EPB actuator
LH (left-hand)EPB actuat
Front Side Member Closing Panel
Removal
NOTES:
The front side member closing panel is manufactured from RP260.
The front side member closing panel is serviced as part of the front side member
and suspension top mount assembly.
This method describes the LH front side member closing panel, the RH side is
similar.
The panel is s
© 2011-2025 Copyright www.rrevoque.org
