Range Rover Evoque: Tyre pressure compensation for low ambient temperature changes

Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Tyres / Tyre pressure compensation for low ambient temperature changes

A colder ambient local temperature will reduce pressure within the tyre. An effect is to decrease sidewall height and to increase tyre shoulder wear with the potential for tyre failure.

Vehicle dynamics could also be adversely affected.

Tyre pressures can be adjusted to compensate before the start of the journey. Alternatively, tyre pressures can be adjusted when the area of lower ambient temperature is reached.

In this situation, the vehicle must be left in the ambient local temperature for at least one hour before tyre pressure is adjusted.

To compensate for colder ambient temperatures, tyre pressures should be increased by 0.14 bar (2 psi, 14 kPa) for each 10°C (20°F) decrease.

Note: Ensure that correct tyre pressures are maintained when moving to areas of differing ambient temperature.

READ NEXT:

 Tyre pressure compensation - high ambient temperatures

 Flat spots due to long term parking

In order to minimise flat spotting, the tyre pressures can be increased to the maximum as stated on the tyre sidewall, for the period when the vehicle is stationary. Tyres must be returned to the

 Age degradation

Tyres degrade over time due to the effects of ultraviolet light, extreme temperatures, high loads, and environmental conditions. It is recommended that tyres are replaced at least every six years,

SEE MORE:

  Front Door Window Regulator and Motor

Removal NOTE: Removal steps in this procedure may contain installation details. 1. WARNING: To avoid accidental deployment, the restraints control module backup power supply must be depleted. Wait at least two minutes after disconnecting the battery ground cable(s) before commencing any repair or ad

  Glass Roof Panel

Removal CAUTIONS: Always protect paintwork and glass when removing exterior components. Always protect the interior components when removing body glass. Measure all gaps between the glass roof panels before prior to removal to help aid installation. Lay the glass on felt covered supports. Do not

© 2011-2026 Copyright www.rrevoque.org - 0.0044