Range Rover Evoque: Windscreen wipers
Windscreen wipers
1. Rotate the collar to adjust the intermittent period. The intermittent delay period will vary and is controlled by either vehicle speed or a rain sensor. The control must be in position (4) to be operational. This is a dealer configurable option.
2. High speed wipe.
3. Low speed wipe.
4. AUTO or intermittent wipe. Controlled by either a rain sensor or vehicle speed. In this position, the rain sensor becomes active and will determine when the wipers are required to operate. If the rain sensor is not configured by your dealer, intermittent wipe will operate in conjunction with the setting of control (1).
5. Rear window wash/wipe: - Press and hold to operate the rear washer and wiper. The wiper will operate for two further wipes after the button is released. After a few seconds a drip wipe process will clear any residual water.
6. Single wipe of windscreen, or hold down for further continuous wipes.
7. Windscreen wash/wipe: - Pull and hold to operate the front washers and wipers. The wipers will operate for three further wipes after the stalk is released. After a few seconds a drip wipe will clear any residual water.
8. INT - rear wiper, intermittent operation.
The intermittent delay period is controlled by adjusting the collar (1). The delay period and number of wipes will then be adjusted automatically depending on vehicle speed.This is a dealer configurable option.
9. ON - rear wiper, continuous operation.
Do not operate the windscreen
wipers
on a dry screen.
In freezing or very hot conditions,
ensure that the wipers have not stuck to
the glass.
Remove any snow, ice or frost from the
screen, around the wiper arms and
blades and the screen scuttle, before
operating the wipers.
Note: If wiper blades become stuck or jammed, an electronic cut-out will temporarily halt wiper operation. If this happens, switch off the wipers and the ignition. Clear any obstructions and free the wiper blades, before attempting to switch on the ignition.
Note: Front wipers will not operate while the bonnet is open and vehicle speed is below 3km/h (1.9mph).
READ NEXT:
Rain sensor/speed sensitive wiper control
Intermittent operation of the wipers is
controlled initially by either vehicle speed or a
rain sensor located at the upper edge of the
windscreen. Both methods of control will clear
the screens ad
Rain sensor
Ensure that the wipers are
switched off
before entering a car wash. If the rain
sensitive wipers operate during the car
washing process, damage may occur to
the wiper mechanism.
The rain senso
Speed sensitive wipers
If vehicle speed drops below 6km/h (3.7mph)
with the wipers operating in positions (2) or
(3), the wipers will switch to the next lowest
speed. When vehicle speed increases to over
6km/h (3.7mph),
SEE MORE:
Isofix child seat positions
Isofix child seat positions
- IUF = Suitable for ISOFIX forward child
restraint systems of universal category
approved for use in the mass group.
- IL = These ISOFIX child restraint systems
are of the specific vehicle, restricted or
semi-universal categories.
- X = Not suitable for ISOFIX c
B-Pillar Outer Panel
Removal
NOTES:
Within this procedure there are 2 different options depending on type of
vehicle body.
The b-pillar outer panel is manufactured from mild steel.
The rocker panel butt joints must be MIG brazed due to the location of boron
reinforcements.
1. The B-Pillar outer panel is replaced in
