Range Rover Evoque: Changing a road wheel

Changing a road wheel
1. Temporary spare wheel locking ring.
2. Temporary spare wheel retaining bolt.
3. Tool kit retaining bolt.
4. Jack.
5. Wheel brace.
After use, the tool kit
should be
returned to the under floor storage
area and correctly stowed.
The spare wheel is heavy and if
handled incorrectly may cause injury.
Use extreme caution when lifting or
manoeuvring the wheels.
Always secure the spare wheel, or the
removed wheel, in the correct position
using the retaining bolt.
Always remove the temporary spare wheel
before jacking the vehicle.
Note: Examine the jack occasionally, clean and
grease the moving parts, particularly the screw
thread, to prevent corrosion.
READ NEXT:
Remove the spare wheel prior
to
jacking the vehicle, to avoid
destabilising the vehicle when raised.
Do not use power tools to
loosen the
spare wheel. Doing so may damage the
mechanism.
1.
Always adhere to the
instructions
given on the temporary use spare
wheel warning label. Failure to
comply can be dangerous.
When a temporary use spare wheel is
fitted, drive with caution and r
Note: Wheel chocks are not supplied as part of
the tool kit.
Wheel chocks are a useful addition to a vehicle
tool kit. Note the following advice when using
wheel chocks.
Before raising the vehic
SEE MORE:
Use only cleaning products
specifically
designed for use on leather. Do not use
solvents. Do not use chemical, alcohol,
or abrasive materials, as they will cause
rapid deterioration of the leather. The
use of products which are not approved
will invalidate your warranty.
If you are in any
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Make the SRS system safe.
Refer to: Standard Workshop Practices (100-00 General Information,
Description and Operation).
2. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery
© 2011-2025 Copyright www.rrevoque.org
