Range Rover Evoque: Headlamp Adjustment

NOTE: The headlamp setting is 1.2 % below horizontal and parallel.

1. Align the headlamp beam setting equipment to one headlamp.

2. Switch the headlamps on and to dipped beam.

3. NOTE: NAS vehicles have vertical adjustment only.

• Adjust the headlamps with an Allen Key.
• Rotate the adjuster 'A' for horizontal alignment.
• Rotate the adjuster 'B' for vertical alignment.

4.

• To adjust the second headlamp, repeat the above procedure.

Front Fog Lamp Adjustment

NOTE: Some variation in the illustrations may occur, but the essential information is always correct.

1. NOTE: The fog lamp beam should be set at 2% below the horizontal and parallel. Check the fog lamp beam alignment.

2. Align the beam setting equipment 2. to one fog lamp.

3.

4. Adjust the fog lamp.

5. To adjust the second fog lamp, repeat the above procedure.

Front Fog Lamp LH

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

2. Remove the LH front wheel and tire.

Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).

3. CAUTION: Take extra care not to damage the component.

4.

5. NOTE: RH illustration shown, LH is similar.

Torque: 2 Nm

Installation

1. To install, reverse the removal procedure.

2. Check the fog lamp beam alignment.

Refer to: Front Fog Lamp Adjustment (417-01 Exterior Lighting, General Procedures).

READ NEXT: