Range Rover Evoque: Before programming
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Garage door opener / Before programming
When programming a device
that may
require you to press and re-press the
hand-held transmitter (cycle), unplug
the device during the cycling process to
prevent possible motor failure.
For best results, fit a new battery to the hand-held transmitter of the garage door opener (or other device) before programming.
If your garage door opener receiver (located in the garage) is equipped with an antenna, ensure that the antenna is hanging straight down.
READ NEXT:
Programming
Programming
With the engine switched off;
1. Ensure that the ignition system is on.
2. Hold the signal emitting end of the original
garage door opener hand-held transmitter
50 to 150 mm (2 to 6
Rolling code device equipment programming
Note: The assistance of a second person, may
make the following steps quicker and easier.
Once the button has been pressed there are
only 30 seconds in which to complete Step 3.
1. At the garage d
Reprogramming a single garage door opener button
To programme a device to a previously
programmed button:
1. Press and hold the desired
pre-programmed HomeLink button for at
least 20 seconds, but no longer than 30
seconds, until the indicator l
SEE MORE:
Stop/start (manual transmission only)
The Stop/Start system has been designed to
improve fuel efficiency. The system is
automatically activated when the ignition is
switched on.
When the engine has been stopped by the
stop/start system, the ECO icon will illuminate.
When the vehicle comes to a stop,
neutral is selected and the
Opening and closing the bonnet
Opening and closing the bonnet
Opening
1. Pull the bonnet release lever, located in the
left-hand front footwell.
2. Lift the bonnet safety catch lever, located
below the centre point of the bonnet, then
raise the bonnet.
Closing
Do not drive with the bonnet
retained
by the safety catc
© 2011-2025 Copyright www.rrevoque.org
