Range Rover Evoque: Disabling stop/start
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Starting the engine / Disabling stop/start
Disabling stop/start
To switch the system off (preventing automatic stop/start) press the ECO switch. The LED indicator will extinguish to confirm that the system is off.
Note: The engine will restart automatically If the switch is pressed to disable the system, while an automatic engine stop is in progress.
If the LED indicator fails to illuminate at start up, a system fault may be present. Contact your Land Rover dealer for assistance.
READ NEXT:
Eco stall recovery
In the event that the engine stalls, it can be
restarted by fully depressing the clutch pedal.
Note: Automatic stall restart will only operate
once. If the engine is stalled a second time the
engi
Emission control system
Land Rover vehicles are fitted with emission
and evaporative control systems. In many
countries it is unlawful to tamper, modify or
replace such equipment and legal penalties
apply if the laws are
Diesel particulate filter (DPF)
Diesel vehicles equipped with a particulate filter
have more efficient emission control. The
particles in the exhaust gases are collected in
the filter during normal driving.
When a DPF message is
SEE MORE:
Drive Pinion Front Bearing
Special Tool(s)
100-012
Slide Hammer
205-067
Preload Gauge
308-615
Remover, Seals
JLR-205-972
Mounting Bracket, Rear Axle
JLR-205-984
Remover/Installer, Drive Pinion Nut
JLR-205-985
Remover, Drive Pinion Bearing
JLR-205-986
Installer, Drive Pinion Bearing
Removal
1. Raise and support the vehicle.
2.
Engine Wiring Harness GTDi 2.0L Petrol
Removal
CAUTIONS:
Make sure that the wiring harness is not twisted or damaged on removal. Failure
to follow this instruction may result
in damage to the vehicle.
Take extra care not to damage the wiring harness clips.
NOTE: Removal steps in this procedure may contain installation details.
1. Disc
© 2011-2025 Copyright www.rrevoque.org
