Range Rover Evoque: Valet

Selection:

Valet mode allows the vehicle to be driven and locked by a parking attendant, without giving access to the luggage compartment. Valet mode also prevents operation of the touch screen, to prevent access to telephone numbers or navigation addresses.

From the Home menu, select Valet: Enter a memorable four digit Personal identification Number (PIN). On completion, touch the OK soft key.

If you wish to cancel the PIN, select Delete.

If the PIN is cancelled, or incorrectly entered, you will be prompted to enter the PIN again.

Valet mode activated is displayed to indicate that the PIN has been accepted.

The luggage compartment is now securely locked in Valet mode and the Valet mode On screen is displayed.

Deselection:

When you re-enter the vehicle, touch the Valet button to view the Valet mode screen.

Enter your four digit PIN and touch the OK button.

Valet mode deactivated is displayed to indicate that your PIN has been accepted.

- The luggage compartment will return to the previously set security requirement.

- The touch screen will be enabled.

Note: If the PIN is forgotten, Valet mode can only be deactivated by your Dealer/Authorised Repairer.

READ NEXT:

 Extra features

There are more features available than can be displayed at one time. This menu allows the selected features to be displayed, for example: - Ambient lighting: While the headlamps are turned on, sel

 Touch screen care

Do not use abrasive cleaners on the touch screen. For approved cleaning products, contact your Dealer/ Authorised Repairer. The touch screen and inner bezel must be kept clean to maintain opti

 Camera systems

SEE MORE:

 Headlamps

Moving the nearside headlamp unit to access bulbs; 1. Remove the two plastic fixings. 2. Pull the tube up to release from the air box. This will allow more room for manoeuvrability. 3. Remove the four grille fixings. 4. Remove the two retaining bolts. 5. At the rear of the headlamp unit, p

 Transfer Case Connecting Sleeve Seals TD4 2.2L Diesel, Vehicles With: M66 6-Speed Manual Transmission AWD

Special Tool(s) 100-012 Slide Hammer 303-1300 Remover, Crankshaft Seal 303-538 Remover/Installer, Crankshaft Oil Seal 307-594 Installer, Seal 307-595 Installer, Intermediate Shaft Seal 308-615 Remover, Seals Removal NOTE: Some variation in the illustrations may occur, but the essential information

© 2011-2025 Copyright www.rrevoque.org