Range Rover Evoque: Engine starting: manual transmission
Note: Do not press the accelerator pedal when
starting the engine.
1. A valid Smart Key must be inside the
vehicle.
2. Fully depress the clutch pedal.
3. Press and release the start button. For
diesel engined vehicles there may be a
delay while the glow plugs warm up, then
the engine will crank automatically until it
starts.
READ NEXT:
Note: If the engine fails to crank when the
START/STOP button is pressed and there has
been a recent collision, seek qualified
assistance.
If the engine fails to crank, or fails to start,
consult
Before switching off the engine, ensure that the
vehicle is parked safely with the park brake
applied.
1. Select P for automatic transmission, or
neutral for manual transmissions.
Note: If any ot
It is not advisable to switch
off the
engine while the vehicle is moving.
However, should such a situation
arise, then the following procedure
applies.
- Press and hold the engine START/STOP
SEE MORE:
Removal
NOTES:
Some variation in the illustrations may occur, but the essential
information is always correct.
Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Remove the front wheels
P should normally be selected before switching
off the engine. If any other gear is selected at
turn off, the selector will move to P before
retracting into the centre console.
If the engine is switched off with N selected, the
system will wait for 10 minutes before
selecting P. This time dela
© 2011-2025 Copyright www.rrevoque.org
