Range Rover Evoque: Fuse box locations
Fuse box locations
When a fuse box lid is
removed, take
care to protect the box from moisture,
and refit the lid at the earliest
opportunity.
Engine compartment - fuse box access: 1. Remove the two plastic fixings.
2. Pull the tube up to release from the air box.
3. Delatch the tabs. The fuse box can now be opened.
The engine compartment fuse numbers and positions are shown on the inside of the fuse box cover.
Passenger compartment - fuse box access.
There are two covers.
4. To access the upper part, open the glovebox and remove the panel from the glovebox liner. A label on the panel shows the circuits protected and the fuse locations.
5. To access the lower part, remove the lower access panel.
Luggage compartment - fuse box access: 6. Remove the panel from the left side trim of the luggage compartment.
READ NEXT:
Changing a fuse
Always turn off the ignition
system and
the affected electrical circuit, before
replacing a fuse.
Fit Land Rover approved replacement
fuses of the same rating and type, or
fuses of matching sp
SEE MORE:
Tyre repair kit
If you are in any doubt
regarding your
ability to carry out the instructions,
contact your Dealer/Approved
Repairer before attempting the repair.
Your vehicle may not be equipped with a spare
tyre. If this is the case, your vehicle will be
fitted with a Land Rover tyre repair kit which
can
Transfer Case
Connecting Sleeve Seals TD4 2.2L Diesel, Vehicles With: M66 6-Speed
Manual Transmission AWD
Special Tool(s)
100-012
Slide Hammer
303-1300
Remover, Crankshaft Seal
303-538
Remover/Installer, Crankshaft Oil Seal
307-594
Installer, Seal
307-595
Installer, Intermediate Shaft Seal
308-615
Remover, Seals
Removal
NOTE: Some variation in the illustrations may occur, but the essential
information
