Range Rover Evoque: Operating the tailgate

of 1.0M Ensure there is minimum space of 1.0M (39 in) above the rear of vehicle before operating the tailgate. Insufficient space may result in damage to the vehicle.

if a cycle Do not operate the tailgate if a cycle rack is fitted to the tailgate. Remove any cycles and/or racks before operating the tailgate.

There are two types of tailgate, powered and manual.

Both types of tailgate can be released using:
- the appropriate button on the Smart Key,
- the internal release switch,

- the external release switch on the tailgate.

- the external release switch on the tailgate.

Note: The tailgate will not open if the vehicle is travelling at or above approximately 5km/h (3.1mph).

Note: When using the external release switch, all doors must be unlocked and the gear selector in Park (P) position.

Note: If the Smart Key is inadvertently left inside the luggage compartment and the vehicle is locked and the alarm set, an audible warning will sound and the tailgate will re-open after three seconds.

READ NEXT:

 Powered tailgate operation

1. Press to open the powered tailgate. 2. Press and release to close the powered tailgate. After the tailgate has opened to its set height, it can be manually raised or lowered. If the tailgate

 Powered tailgate opening height

The maximum opening height can be set as required. This is useful in parking areas with low ceiling heights or just for ease of use. 1. Open the tailgate to the position which you want to set as t

 Programmed position loss

The powered tailgate may lose its position memory if there are multiple object detections or if battery voltage is low. Powered operation may be inhibited. To reset the tailgate; 1. Manually close

SEE MORE:

 Rocker Panel Inner Reinforcement

Removal NOTES: The rocker panel inner reinforcement is manufactured from boron steel. The rocker panel inner reinforcement is unpicked from the side panel reinforcement 'ring-frame', it is not serviced separately. In this procedure the b-pillar reinforcement will be fitted in combination with th

 Front Wheel Bearing

Special Tool(s) 204-305 Remover, Wheel Bearing 204-726 Remover/Installer, Wheel Bearing 204-727A Installer, Wheel Bearing JLR-204-806 Support Tool, Wheel Knuckle JLR-204-807 Installer, Front Wheel Bearing JLR-204-808 Installer, Front Wheel Bearing General Equipment Copper Hammer Hydraulic press

© 2011-2025 Copyright www.rrevoque.org