Range Rover Evoque: Settings - options
- If the Link DAB setting is switched on and the signal strength for a channel falls below an acceptable level, the audio unit will automatically search other available ensembles for a channel with the same name.
If an alternative local channel is found, the new channel is played automatically after few seconds. If the channel is not found after a few seconds, the message No reception is displayed.
The word Link is displayed at the top of the touch screen when Link DAB is enabled.
- Select DAB country if you drive into another country. Scroll through the country options to choose the appropriate one.
This will prompt an auto tune.
Note: This option is disabled while the vehicle is moving.
- Choose DAB format if you move to a region that uses a different digital band. Available formats are;
- L Band
- Band III
- L Band & Band III
- L Band Canada
- L Band Can & Band III
This will prompt an auto tune.
Note: This option is disabled while the vehicle is moving.
READ NEXT:
Digital radio reception
DAB radio can significantly increase the
number of radio channels/stations available.
The DAB signals are transmitted to most major
cities, towns and motorway networks.
Digital radio is transmitte
Ensembles
Unlike AM/FM radio, DAB transmits several
channels/stations on a single frequency. A
group of channels is known as an ensemble.
Some channels within the ensemble may have
subchannels offering seve
SEE MORE:
Keyless
Vehicle Module (KVM)
Remote Keyless Entry Module (RFA)
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a fault and may also cause additional faults in
the vehicle being checked and/or the donor
vehicle.
NOTES:
If
Front Seat Backrest Heater Mat
Removal
WARNINGS:
To avoid accidental deployment and possible personal injury, the backup
power supply must be depleted before
repairing or replacing any air bag supplemental restraint system (SRS)
components. To deplete the backup power supply
energy, disconnect the battery ground cable and wait
