Range Rover Evoque: Throttle Body
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some illustrations may show the engine removed for clarity.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Refer to: Engine Cover - GTDi 2.0L Petrol (501-05 Interior Trim and Ornamentation, Removal and Installation).
3. Refer to: Engine Undershield (501-02 Front End Body Panels, Removal and Installation).
4.
5.
6.
7. NOTE: Install a new O-ring seal. Torque: 8 Nm
Installation
1. To install, reverse the removal procedure.
Fuel Injectors
Removal
1. Refer to: Fuel Rail (303-04C Fuel Charging and Controls - GTDi 2.0L Petrol, Removal and Installation).
Installation
1. To install, reverse the removal procedure.
Fuel Charging Wiring Harness
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
2. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
3. Refer to: Intake Manifold (303-01B Engine - GTDi 2.0L Petrol, Removal and Installation).
4.
5.
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Fuel Rail
Special Tool(s)
310-198
Installer, Teflon Seal
310-199
Re-shape Tool, Teflon Seal
Removal
CAUTION: Make sure that all openings are sealed. Use new blanking caps.
NOTE: Some variation in the illustrat
Fuel Pump
Removal
WARNING: This procedure involves fuel handling. Be prepared for fuel
spillage at all times and always observe fuel
handling precautions. Failure to follow these instructions may result in
pe
Fuel Charging and Controls - Turbocharger - GTDi 2.0L Petrol
Torque Specifications
Turbocharger
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is
always
SEE MORE:
Front Seat Recliner Motor
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
2. Refer to: Standard Workshop Practices (100-00 General Information,
Description and Operation).
3. Refer to: Front Seat Co
Washer fluid check
Do not allow screen washer
fluid to
come into contact with naked flames
or sources of ignition.
If the vehicle is operated in
temperatures below 4°C (40°F), use a
washer fluid with frost protection.
Only use approved washer
fluid.
Take care to avoid spillage, particularly
if an undil
