Range Rover Evoque: Timing Chain
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is always correct.
1. Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
2. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
3. Refer to: Timing Cover (303-01B Engine - GTDi 2.0L Petrol, Removal and Installation).
4.
5.
6.
7.
8. CAUTIONS:
Use an open-ended wrench to hold the camshafts by the hexagon to prevent the camshafts from turning.
Note the fitted position of the component prior to removal. Do not disassemble further if removed for access only
9.
Installation
1. CAUTION: Install a new friction washer.
2. CAUTIONS:
Use an open-ended wrench to hold the camshafts by the hexagon to prevent the camshafts from turning.
Make sure that these components are installed to the noted removal position.
Only tighten the bolts finger-tight at this stage.
3.
4. Torque: 10 Nm
5. Torque: 10 Nm
6. CAUTION: Use an open-ended wrench to hold the camshafts by the hexagon to prevent the camshafts from turning. Torque: 72 Nm
7. Refer to: Timing Cover (303-01B Engine - GTDi 2.0L Petrol, Removal and Installation).
8. Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
READ NEXT:
Timing Cover
Special Tool(s)
303-021
Engine support bracket
JLR-303-1591
Lifting Bracket, Engine - Rear
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustratio
Valve Cover
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is
always correct.
Removal steps in this proc
Engine - Removal and Installation
Removal
Special Tool(s)
205-857
Remover, Halfshaft
1. Refer to: Battery Tray (414-01 Battery, Mounting and Cables,
Removal and Installation).
2. Refer to: Air Conditioning (A/C) System Recovery, Evacu
SEE MORE:
Information and assistance
It is recommended that when
you sell or
dispose of the vehicle, the programmed
HomeLink buttons be erased for
security purposes.
For information on the range of available
compatible products or accessories, or for
assistance, you should contact your Dealer/
Authorised Repairer.
You can als
Mirror dip when reversing
If the vehicle is equipped with memory seats,
when reverse gear is selected the door mirrors
can be set to automatically adjust, providing an
improved viewing angle of the curb side for
reversing. The Reverse-dip mirror feature
must be switched on. See 56, VEHICLE
INFORMATION AND SETTINGS MENU
