Range Rover Evoque: Window reset

If the battery is disconnected or the power supply is interrupted, the windows must be reset.

Once the power supply is restored, reset as follows: 1. Close the window fully.

2. Release the switch, then lift it to the close position and hold for 1 second.

3. Repeat the procedure on each window.

READ NEXT:

 Anti-trap protection

Closing a window or roof blind onto any part of the body can result in serious injury. Before closing a window or the roof blind, ensure that no occupants have any part of their body in a posi

 Resonance with lowered windows

if a resonance or booming sound occurs when a rear window is open, lowering an adjacent front window by approximately 25mm (1 inch) will eliminate the condition.

 Mirrors

SEE MORE:

 Engine Oil Draining and Filling, Camshafts

Engine Oil Draining and Filling Draining NOTE: Removal steps in this procedure may contain installation details. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Remove the engine undershield. Refer to: Engine Undershield (501-02 Front End Body Panels

 Wipers and Washers - Component Location, System Operation and Component Description

Component Location COMPONENT LOCATION - SHEET 1 OF 2 Central Junction Box (CJB) Integrated Control Panel (ICP) Rain/Light sensor (if fitted) Right tailgate actuator (upper) Rear wiper motor Left tailgate actuator (upper) Rear Junction Box (RJB) Wiper control switch Instrument Cluster (IC)

© 2011-2025 Copyright www.rrevoque.org