Range Rover Evoque: Commandshift™

To return to Sport mode after CommandShift has been selected, move the selector back to D then back to Sport mode. Transmission Commandshift Selected will appear in the message centre when the transmission is in CommandShift mode.

Note: In order to protect the engine, the transmission will automatically change up to prevent over-revving, or down if the engine is labouring.

READ NEXT:

 Kick-down

Push the accelerator pedal fully down to achieve rapid acceleration in automatic mode. When the pedal is relaxed, normal gear changing will resume.

 Drive selector

P should normally be selected before switching off the engine. If any other gear is selected at turn off, the selector will move to P before retracting into the centre console. If the engine is sw

 Drive selector fails to elevate

If the drive selector is obstructed, remove the obstruction and then start the engine. The selector should elevate as normal. If the selector still fails to elevate, even if there is no obstructio

SEE MORE:

 Anti-Lock Control - Stability Assist

Accelerometer Removal NOTES: Removal steps in this procedure may contain installation details. LHD illustration shown, RHD is similar. Vehicles with automatic transmission 1. Refer to: Floor Console Upper Section (501-12 Instrument Panel and Console, Removal and Installation). 2. Torque: 9 Nm Vehi

 Cleaning after off-road driving

Ensure that the areas around air intakes and the front grille are clean and clear of debris. Pay particular attention to the lower grille and radiator. Failure to do so may cause the engine to overheat, leading to severe engine damage. Ensure that the vehicle underside is cleaned as soon

© 2011-2025 Copyright www.rrevoque.org