Range Rover Evoque: How it works
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Dual view / How it works
Viewing angles for driver and front seat passenger are such that neither can view the full display that the other is viewing. However, there is an optimum viewing angle of 30 degrees where no cross over of images can be perceived. From this point, the closer to screen centre or screen side edges that the viewer moves to, the more likely cross over of images is. During normal use of dual view, image cross over is unlikely.
Rear seat passengers may be able to see both views when dual view is active.
READ NEXT:
Dual view selection
When the ignition is switched on or the audio
unit is turned on after being turned off, single
view mode will be the default view.
To select dual view, press the dual view hard
key on the fascia s
Dual view control menu
Dual view control menu
1. Select to cancel dual view and revert to the
menu for the current video source (TV,
DVD).
Note: The preview screen will be
deactivated if the vehicle is moving.
2. Se
Dual view tv operation
If you would like to change the TV programme
while the vehicle is moving, there are two
methods available;
1. Press the dual view hardkey to display the
control menu.
Select an alternative channe
SEE MORE:
Inner Constant Velocity (CV) Joint Boot
Special Tool(s)
303-D121
Puller, General Purpose
General Equipment
Vise
Removal
NOTE: RH inner constant velocity joint boot shown, LH is similar.
1. Refer to: Rear Halfshaft LH (205-05 Rear Drive Halfshafts, Removal
and Installation).
Refer to: Rear Halfshaft RH (205-05 Rear Drive Halfshafts, Re
Control Diagram, System Operation
Control Diagram
NOTE: A = Hardwired; D = High speed CAN (controller area network) bus; O =
LIN (local interconnect network) bus
Battery
BJB (battery junction box)
Front height sensor
Rear height sensor
Headlamp leveling control module
Front right fog lamp
Front left fog lamp
Left side rep
© 2011-2025 Copyright www.rrevoque.org
