Range Rover Evoque: Rear Quarter Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Refer to: Rear Seat Cushion (501-10 Seating, Removal and Installation).
2. Refer to: Loadspace Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
3.
4.
5.
6. CAUTION: Discard the bolt.
NOTE: 5-door illustration shown, 3-door is similar.
Torque: 45 Nm
7.
8. NOTE: Do not disassemble further if the component is removed for access only.
9.
Installation
1. CAUTIONS:
Make sure that a new bolt is installed.
Make sure the safety belt is secure and correctly installed.
NOTE: Make sure the safety belt is operating correctly.
To install, reverse the removal procedure.
B-Pillar Upper Trim Panel 3-Door
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2.
3. CAUTION: Discard the bolt.
NOTE: 5-door illustration shown, 3-door is similar.
Torque: 45 Nm
4.
5. Torque: 6 Nm
6.
7. NOTE: 5-door illustration shown, 3-door is similar.
Installation
1. WARNING: Make sure that a new bolt is installed.
CAUTION: Make sure the safety belt is secure and correctly installed.
NOTE: Make sure the safety belt is operating correctly.
To install, reverse the removal procedure.
Interior Trim and Ornamentation
Torque Specifications
READ NEXT:
Exterior Trim and Ornamentation
Torque Specifications
Rear Quarter Panel Moulding
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2. NOTE: Discard the retaining clips.
Make sure that the centre
Rear View Mirrors
Rear View Mirrors - Component Location
NOTE: RHD (right-hand drive) installation shown, LHD (left-hand drive)
installation similar.
DDM (driver door module)
Driver exterior mirror
Exterior mirro
SEE MORE:
Front Side Member
Removal
NOTES:
The front side member is manufactured from RP260 and DP600.
The front side member long section is cut from the front side member and is
manufactured from RP260.
The service panel is serviced not fully spot welded.
1. In this procedure, to make sure the vehicle is correctly aligned,
Automatic switch off
Cruise control will switch off but the set speed
will remain in the memory when:
- The CAN button (3) is pressed.
- The brake pedal is pressed.
- Speed falls below 30km/h (18mph).
- Neutral, Park or Reverse gear is selected
on vehicles with automatic transmission.
- Dynamic Stability Control
