Range Rover Evoque: After towing on four wheels

1. Apply the parking brake. For vehicles with an automatic gearbox, apply the footbrake and then select Park position.

2. Switch off the ignition and remove the Smart Key from the vehicle.

3. Remove the towing attachment and refit the cover panel to the front bumper.

detaching Use extreme caution when detaching towing equipment. Vehicle movement is possible which can result in serious injury.

READ NEXT:

 After a collision

 Before starting or driving

If the vehicle is involved in a collision it should be checked by a Dealer/ Authorised Repairer, or suitably qualified persons, before starting or driving.

 Event data recording

Event data recorders are capable of collecting and storing short sequences of data during a crash or near-crash event. The recorded information may assist in the investigation of such an event. Th

SEE MORE:

 Anti-Theft - Active

Anti-Theft - Active - Component Location COMPONENT LOCATION RH (right-hand) front door module RH front door latch mechanism Radio Frequency (RF) receiver RH rear door module RH rear door latch mechanism Interior motion sensor Remote handset Liftgate latch mechanism Keyless Vehicle Module

 Inner Back Panel Assembly

Removal NOTES: The inner back panel assembly is manufactured from mild steel. The panel is serviced less its weld studs. The new service panel is not fully spot welded when supplied. It is necessary to remove a section of one rear lamp mounting panel to enable removal and installation of the inn

© 2011-2025 Copyright www.rrevoque.org