Range Rover Evoque: Before programming

that may When programming a device that may require you to press and re-press the hand-held transmitter (cycle), unplug the device during the cycling process to prevent possible motor failure.

For best results, fit a new battery to the hand-held transmitter of the garage door opener (or other device) before programming.

If your garage door opener receiver (located in the garage) is equipped with an antenna, ensure that the antenna is hanging straight down.

READ NEXT:

 Programming

Programming With the engine switched off; 1. Ensure that the ignition system is on. 2. Hold the signal emitting end of the original garage door opener hand-held transmitter 50 to 150 mm (2 to 6

 Rolling code device equipment programming

Note: The assistance of a second person, may make the following steps quicker and easier. Once the button has been pressed there are only 30 seconds in which to complete Step 3. 1. At the garage d

 Reprogramming a single garage door opener button

To programme a device to a previously programmed button: 1. Press and hold the desired pre-programmed HomeLink button for at least 20 seconds, but no longer than 30 seconds, until the indicator l

SEE MORE:

 Changing a fuse

Always turn off the ignition system and the affected electrical circuit, before replacing a fuse. Fit Land Rover approved replacement fuses of the same rating and type, or fuses of matching specification. Using an incorrect fuse, may result in damage to the vehicle's electrical system and

 Automatic Transmission/Transaxle External Controls - Vehicles With: AWF21 6-Speed Automatic Transmission

General Specification Torque Specifications External Controls - Component Location COMPONENT LOCATION Downshift paddle switch Upshift paddle switch Transmission Control Switch (TCS) External Controls - Overview OVERVIEW The external controls comprise a rotary TCS (transmission control switch

© 2011-2025 Copyright www.rrevoque.org