Range Rover Evoque: Daytime running lamps
Daytime running lamps are LED lamps.
With the lighting control in the OFF position or
in AUTO position while lighting conditions do
not require headlamps on, then daytime
running lamps will switch on automatically
under the following conditions:
- The engine is running.
- The gear selector is out of park (automatic
transmission).
- The parking brake is not applied - market
dependent.

Unless required or prohibited by law,
daytime running lamps can be disabled
or enabled by your Dealer/Authorised
Repairer.
READ NEXT:
This feature operates whenever the lamps
master switch is in the AUTO (5) position and
the ignition is turned off. The headlamps will
remain illuminated for up to 240 seconds.
Note: The time delay
This feature of the Xenon lighting automatically
selects and deselects high beam, under
specific conditions of road lighting and in the
absence of other vehicle’s lights. The system is
only acti
If Auto lamps is selected and the windscreen
wipers are switched on for 20 seconds or
more, the side lamps, tail lamps and
headlamps will switch on automatically. When
the wipers are switched off,
SEE MORE:
Control Diagram
NOTE: A = Hardwired; D = High Speed Controller Area Network (CAN) bus; O =
Local Interconnect Network ( LIN)
Battery
Battery Junction Box (BJB)
Engine Control Module (ECM)
Central Junction Box (CJB)
Transmission paddle switches
Clockspring
Auxiliary battery module
Transmis
CAUTION: If
the front airbags are deployed, the following components must be replaced:
Driver airbag module
Steering wheel
Passenger airbag module
Instrument panel
Fly leads (where applicable) connecting front airbag modules to SRS
harness
All seat belt buckle pre-tensioner
All occupied
© 2011-2025 Copyright www.rrevoque.org
