Range Rover Evoque: Dual view selection
When the ignition is switched on or the audio
unit is turned on after being turned off, single
view mode will be the default view.
To select dual view, press the dual view hard
key on the fascia surround. See 111,
AUDIO/VIDEO CONTROLS.
Press again to display the dual view Options
menu. From here, a change can be made to the
viewing source or dual view can be cancelled.
If TV or a video format source were being
viewed previously, the same source will be
displayed.
READ NEXT:
Dual view control menu
1. Select to cancel dual view and revert to the
menu for the current video source (TV,
DVD).
Note: The preview screen will be
deactivated if the vehicle is moving.
2. Se
If you would like to change the TV programme
while the vehicle is moving, there are two
methods available;
1. Press the dual view hardkey to display the
control menu.
Select an alternative channe
When the video programme begins play, a root
menu with information about the video
programme and its content will be displayed on
screen.
Note: Information and style may vary due to
differing vid
SEE MORE:
EPB will be applied automatically if the ignition
is switched off and the vehicle speed is below
3km/h (2mph).
To prevent automatic operation, when the
vehicle is stationary, press and hold the EPB
switch in the release position. Within 5
seconds, switch off the ignition and continue to
hold
General specifications
Torque Specifications
Brake Pads
Removal
WARNING: Brake pads must be renewed in axle sets only. Failure to follow
this instruction may result in braking
efficiency being impaired.
CAUTION: LH illustration shown, RH is similar.
1. WARNING: Make sure to support the vehicle wi
© 2011-2025 Copyright www.rrevoque.org
