Range Rover Evoque: Entry gate programming

The technology of some entry gates requires you to press and re-press (cycle) the hand-held transmitter button every two seconds during programming.

Continue to press and hold the desired HomeLink button while you cycle your hand-held transmitter until the indicator lamp flashes rapidly.

READ NEXT:

 Information and assistance

It is recommended that when you sell or dispose of the vehicle, the programmed HomeLink buttons be erased for security purposes. For information on the range of available compatible products or

 Instrument panel

Instrument panel 1. Speedometer. 2. Driver Information Centre (message centre). 3. Tachometer. 4. Temperature gauge Serious engine damage can occur if the vehicle is driven while the engin

 Vehicle information and settings menu

Vehicle information and settings menu A number of vehicle features and display settings may be configured via the vehicle information and settings menu. To display and navigate through the vehic

SEE MORE:

 Halfshaft Seal RH Vehicles With: M66 6-Speed Manual Transmission AWD

Special Tool(s) 303-1300 Remover, Crankshaft Seal 303-882 Installer, Halfshaft Seal Removal 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Refer to: Front Halfshaft RH - LHD AWD/RHD AWD (205-04 Front Drive Halfshafts, Removal and Installation). 3. CA

 Front Inner Parking Aid Sensor

Removal CAUTION: LH illustration shown, RH is similar. NOTES: Removal steps in this procedure may contain installation details. The ignition must be switched off. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Refer to: Front Bumper Cover (501-19 B

© 2011-2025 Copyright www.rrevoque.org