Range Rover Evoque: Isofix child seat positions

Isofix child seat positions
Isofix child seat positions

- IUF = Suitable for ISOFIX forward child restraint systems of universal category approved for use in the mass group.

- IL = These ISOFIX child restraint systems are of the specific vehicle, restricted or semi-universal categories.

- X = Not suitable for ISOFIX child restraint fitment in this mass group.

- * = Child seat suitable for use in these locations, is the Britax/Römer Baby Safe Plus

Note: Ages given are approximate. In case of doubt, the child’s weight, not age should be used when considering an appropriate child seat.

Note: The information contained in the table may not be applicable to all countries. If you are in any doubt regarding the type and fitment of child seats seek advice from your Dealer/ Authorised Repairer.

Note: ISOFIX anchorages are provided for second row outer seating positions. ISOFIX child restraints should be securely attached following the manufacturers instructions at these locations only.

READ NEXT:

 Booster cushions

In a situation where a child is too large to fit into a child safety seat but is still too small to safely use just the three point belt, a booster seat is recommended for maximum safety. Follow t

 Installing an isofix child seat

Installing an isofix child seat To install an ISOFIX child seat: 1. Locate the ISOFIX locking mechanism. 2. Slide the child seat into the locking mechanism. 3. If an upper tether is fitted to t

 Tether anchorage points (Australia only)

WARNING: Child restraint anchorages are designed to withstand only those loads imposed by correctly fitted child restraints. Under no circumstances are they to be used for adult seat belts, ha

SEE MORE:

 Side Air Curtain Module

Removal CAUTION: Do not allow the side air curtain module to twist. Failure to follow this instruction may result in damage to the component. NOTES: Removal steps in this procedure may contain installation details. RH illustration shown, LH is similar. 1. Disconnect the battery ground cable. Refe

 Cooling Fan

Removal NOTES: Removal steps in this procedure may contain installation details. Some variation in the illustrations may occur, but the essential information is always correct. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Refer to: Cooling System

© 2011-2025 Copyright www.rrevoque.org