Range Rover Evoque manuals

Range Rover Evoque: Lower Arm

Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Suspension / Front Suspension / Lower Arm

Removal

CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension.

NOTES:

RH illustration shown, LH is similar.

Removal steps in this procedure may contain installation details.

1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

2. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).

3. WARNING: Make sure that a new nut is installed. Torque: 60 Nm

Range Rover Evoque. Front Suspension

4.

Range Rover Evoque. Front Suspension

5. WARNING: Make sure that a new bolt is installed. Torque: 200 Nm

Range Rover Evoque. Front Suspension

6. WARNING: Make sure that a new bolt is installed.

Torque:

Stage 1: 48 Nm
Stage 2: 180

READ NEXT:

 Front Stabilizer Bar AWD

Removal CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. NOTES: Only use clean water as a lubricant for the bushing, if required. Removal steps in this pro

 Front Stabilizer Bar Bushing

Removal NOTES: Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this procedure may contain installation details. 1. WARNING: Make sure

 Wheel Knuckle

Special Tool(s) 205-754A Splitter, Ball Joints 205-857 Remover, Halfshaft JLR-204-804 Lever, Wheel Knuckle Removal CAUTIONS: Nuts and bolts must be tightened with the weight of the vehicle on the sus

SEE MORE:

 Land rover tyre repair kit

Land rover tyre repair kit 1. Maximum speed label. 80 km/h (50 mph). 2. Tyre inflation hose. 3. Inflation hose protective cap. 4. Inflation hose connector. 5. Compressor power cable. 6. Power cable connector. 7. Sealant bottle receiver cap (orange). 8. Sealant bottle receiver. 9. Sealant

 Shock Absorber and Spring Assembly Vehicles With: Dynamic Suspension

Special Tool(s) 205-754A Splitter, Ball Joints 205-857 Remover, Halfshaft JLR-204-804 Lever, Wheel Knuckle General Equipment Transmission jack Wooden Block Removal CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. NOTE: Some variation in the illustratio

© 2011-2025 Copyright www.rrevoque.org