Range Rover Evoque: Rear Door Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Torque: 1.3 Nm

2. Torque: 6 Nm

3. Torque: 6 Nm

4.

5.

6.

7. NOTE: Do not disassemble further if the
component is removed for access only.

8. Torque: 0.6 Nm

9.

10. Torque: 1 Nm

11.

Installation
1. To install, reverse the removal procedure.
Liftgate Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
2. NOTE: Make sure the two metal clips are removed
from the liftgate.

3. NOTE: Do not disassemble further if the
component is removed for access only.

Installation
1. To install, reverse the removal procedure.
READ NEXT:
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Vehicles with glass roof panel shown, vehicles without glass roof panel similar.
All vehicles
1. Refer to: Windshield
Engine Cover GTDi 2.0L Petrol
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2. NOTE: Do not disassemble further if the
component is removed for access only.
Inst
CAUTION: LH illustration shown, RH is similar.
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1.
2.
3.
4. Torque: 1.4 Nm
5. Torque: 20 Nm
6. NOTE: LH side o
SEE MORE:
Door lock and release levers
1. Press a locking lever to lock a door. Pull the
lever back to unlock. Operating either front
door locking levers will lock or unlock all
doors.
2. Pull a release lever to open a front door.
To unlock and open a rear door, first
operate the lock lever, then pul
Care should be taken to avoid
contamination of the webbing with
polishes, oils and chemicals, and
particularly battery acid. Cleaning
may safely be carried out using mild
soap and water.
The belt should be replaced if
webbing becomes frayed,
contaminated or damaged.
It is essential to repl
© 2011-2025 Copyright www.rrevoque.org
