Range Rover Evoque: Child seat positioning

children are Crash statistics show that children are safest when properly restrained in a child or infant restraint system that is secured in a rear seating position.

table is Information given within the table is correct at the time of going to press.

However, availability of child restraints may change. Please consult your Dealer/Authorised Repairer for the latest recommendation.

Note: The information contained in the following table may not be applicable to all countries. If you are in any doubt regarding the type and fitment of child seats seek advice from your Dealer/Authorised Repairer.

Note: Ages given are approximate. In case of doubt, the child’s weight not age should be used when considering an appropriate child seat.

Note: The legislation which governs how and where children should be carried when travelling in a vehicle, is subject to change. It is the responsibility of the driver to comply with all regulations in force.

U = Suitable for universal category restraints

U = Suitable for universal category restraints approved for this mass group.

* Always ensure that the passenger airbag has been disabled before using a child restraint in this seating position. See 36, DISABLING THE PASSENGER AIRBAG (not Australia). The seat back needs to be adjusted to the fully upright position.

READ NEXT:

 Recommended child seats

Recommended child seats

 Child restraint check list

Every time a child travels in the vehicle observe the following: - Use appropriate child restraints. - Carefully follow the restraint system manufacturers instructions. - Adjust the harnesses for

 Isofix anchor points (not Australia)

Do not attempt to fit ISOFIX restraints to the centre rear seating position. The anchor bars are not designed to hold an ISOFIX restraint in this position. If the restraint is not correctly a

SEE MORE:

 Epb automatic use

EPB will be applied automatically if the ignition is switched off and the vehicle speed is below 3km/h (2mph). To prevent automatic operation, when the vehicle is stationary, press and hold the EPB switch in the release position. Within 5 seconds, switch off the ignition and continue to hold

 Liftgate Window Glass

Removal 1. Refer to: Rear Spoiler (501-08 Exterior Trim and Ornamentation, Removal and Installation). 2. 3. 4. CAUTION: The step must be carried out on both sides. 5. CAUTIONS: Protect the surrounding components. Protect the surrounding paintwork to avoid damage. Use a glazing cutting wire to

© 2011-2025 Copyright www.rrevoque.org