Range Rover Evoque: Front Stabilizer Bar Bushing
Removal
NOTES:
Some variation in the illustrations may occur, but the essential information is always correct.
Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Remove the front wheels and tires.
Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
3. WARNING: Make sure that new nuts are installed.
Torque:
Stage 1: 175 Nm
Stage 2: 175 Nm
Installation
1. To install, reverse the removal procedure.
Front Stabilizer Bar Link
Removal
NOTES:
Some variation in the illustrations may occur, but the essential information is always correct.
Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
3. WARNING: Make sure that new nuts are installed.
CAUTION: Use an Allen key to prevent the ball joint rotating whilst removing the nut.
Torque: 60 Nm
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Wheel Knuckle
Special Tool(s)
205-754A
Splitter, Ball Joints
205-857
Remover, Halfshaft
JLR-204-804
Lever, Wheel Knuckle
Removal
CAUTIONS:
Nuts and bolts must be tightened with the weight of the vehicle on the
sus
Front Shock Absorber Vehicles Without: Dynamic
Suspension
General Equipment
Suspension Spring Compressor
Vise
Removal
WARNINGS:
Make sure the spring compressor Safe Working Load (SWL) meets or exceeds
the spring rating quoted in the
Specifcations sectio
Shock Absorber and Spring Assembly Vehicles Without:
Dynamic Suspension
Special Tool(s)
205-754A
Splitter, Ball Joints
205-857
Remover, Halfshaft
JLR-204-804
Lever, Wheel Knuckle
General Equipment
Transmission jack
Wooden Block
Removal
CAUTION: Nuts and bolts must be
SEE MORE:
Portable media connections
Portable media devices can be connected to
the media hub located in the cubby box. The
portable devices that you can connect to the
system include:
- USB mass storage devices (e.g. a memory
stick). Devices must use FAT or FAT32 file
format.
- iPod (iPod Classic, iTouch, iPhone and
Nano are s
Fuel filler flap
Take note of all warnings
and
instructions given on the label affixed
to the inside of the filler flap.
The fuel filler flap is located on the right-hand
side of the vehicle, at the rear.
1. If a locking fuel filler flap is fitted, ensure
that the vehicle alarm system is disarmed.
Note: Th
