Range Rover Evoque: Fuel Filler Door
Removal
CAUTION: Make sure to protect the paintwork.
1.
Installation
1.
Fuel Filler Door Assembly
Removal
WARNING: Avoid flames, sparks or lighted substances.
CAUTION: Extreme cleanliness must be exercised when handling these components.
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is always correct.
Make sure that all openings are sealed. Use new blanking caps.
1. Remove the rear wheel.
Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
2.
3.
4.
5.
6.
7. CAUTION: Make sure to protect the paintwork.
NOTE: Do not disassemble further if the component is removed for access only.
Installation
1.
2. To install, reverse the removal procedure.
READ NEXT:
Body Closures - Component Location, System Operation and Component
Description
Component Location
Powered Tailgate - Component Location
Tailgate module
Powered strut
Tailgate open button
Tailgate close button
Latch assembly
Powered cinch motor
Powered strut
OVERVIEW
Ta
A-Pillar Trim Panel, B-Pillar Upper Trim Panel 5-Door
A-Pillar Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Torque: 6 Nm
Installation
1. To install, reverse the removal procedure.
B-Pillar Upper Trim Pane
SEE MORE:
Rear Wheel Bearing
Special Tool(s)
204-250
Wheel bearing install and removal tool
204-305
Remover, Wheel Bearing
204-726
Remover/Installer, Wheel Bearing
JLR-204-806
Support Tool, Wheel Knuckle
JLR-204-809
Installer, Rear Wheel Bearing
JLR-204-810
Installer, Rear Wheel Bearing
General Equipment
Copper Hammer
Hydrau
Timing Cover
Special Tool(s)
303-021
Engine support bracket
JLR-303-1591
Lifting Bracket, Engine - Rear
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is
always correct.
1. Refer to: Specifications (414-01
