Range Rover Evoque: Rain sensor/speed sensitive wiper control

Intermittent operation of the wipers is controlled initially by either vehicle speed or a rain sensor located at the upper edge of the windscreen. Both methods of control will clear the screens adequately. Vehicle speed control is set by the user and control via a rain sensor is automatic.

enabled/disabled This function can be enabled/disabled by your Dealer/Authorised Repairer.

READ NEXT:

 Rain sensor

Ensure that the wipers are switched off before entering a car wash. If the rain sensitive wipers operate during the car washing process, damage may occur to the wiper mechanism. The rain senso

 Speed sensitive wipers

If vehicle speed drops below 6km/h (3.7mph) with the wipers operating in positions (2) or (3), the wipers will switch to the next lowest speed. When vehicle speed increases to over 6km/h (3.7mph),

 Drip wipe

If the drip wipe function is configured, the wipers will operate four seconds after a wash/wipe cycle has finished, to clear any remaining drips from the windscreen. This function can be enabled

SEE MORE:

 Electronic Engine Controls - Component Location

Component Location COMPONENT LOCATION - SHEET 1 OF 4 Fuel metering valve - HP Fuel pump Camshaft Position (CMP) sensor (2 off) Variable Camshaft Timing (VCT) solenoid (2 off) Purge valve Generator Air Conditioning (A/C) compressor clutch Crankshaft Position (CKP) sensor Turbocharger wasteg

 Steering column

Never adjust the steering column while the vehicle is in motion. 1. Move the lever fully down to unlock the column. Move the lever fully up to re-lock the column. 2. Move the steering column up, down, in or out, to the desired position. 3. Press to switch on the steering wheel heating. Te

© 2011-2025 Copyright www.rrevoque.org