Range Rover Evoque: Seat belt checks
Note: If the vehicle is parked on an incline, the seat belt mechanism may lock. This is not a fault and the belt should be gently eased out from the upper anchorage.
The seat belts should be inspected regularly to check for fraying, cuts, wear to the webbing and the condition and security of the mechanism, buckles, adjusters and mounting points.
- With the seat belt fastened, give the webbing near the buckle a quick upward pull. The buckle must remain securely locked.
- With the seat belt unfastened, unreel the seat belt to the limit of its travel. Check that it unreels smoothly with no snatches or snags. Allow the belt to fully retract, again checking for smooth operation.
- Partially unreel the seat belt, then hold the tongue plate and give a quick forward pull.
The mechanism must lock and prevent any further unreeling.
If any of the seat belts fail to meet those criteria, immediately contact you Land Rover Dealer/Authorised Repairer.
READ NEXT:
Seat belt reminder
Seat belt reminder
If a front seat belt is not fastened
when the vehicle is in motion, a
chime will be heard and the seat
belt warning lamp will illuminate.
Note: Objects on the front passenger
Beltminder
A front and rear seat Beltminder system warns
the driver when the seat belt of an occupied
seat is not fastened or is unfastened during a
journey.
Beltminder
A graphic accompanied by a text mes
Child seats
For optimum
safety, children should
travel in the rear of the vehicle at all
times; front passenger seat travel is
not recommended. However, if it is
essential that a child travels in the
fron
SEE MORE:
Cylinder Block Components - 2.0L GTDi
Component Description
Front crankshaft oil seal
Front cover assembly
Knock sensor - cylinders 1 and 2
Gasket - thermostat housing
Thermostat
Cylinder block
Knock sensor - cylinders 3 and 4
Bolt (2 off)
Bolt (3 off)
Oil pump
Gasket - oil pump inlet
Oil pump filter and pick-up assembly
Oil check preparation
Prior to checking the oil level ensure that:
- The vehicle is on level ground.
- The engine oil is cold.
Note: If it is necessary to check the oil level
when the engine is hot, switch off the engine
and let the vehicle stand for 5 minutes to allow
the oil to drain back into the sump. Do not st
