Range Rover Evoque: Using wheel chocks
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Wheel changing / Using wheel chocks
Note: Wheel chocks are not supplied as part of the tool kit.
Wheel chocks are a useful addition to a vehicle tool kit. Note the following advice when using wheel chocks.
Before raising the vehicle,
the wheel
diagonally opposite the one to be
removed must be chocked.
Always chock the wheels using
suitable wheel chocks. Place the
chocks on both sides of the wheel
diagonally opposite the wheel to be
changed.
If jacking the vehicle on a slight slope
is unavoidable, place the chocks on
the downhill side of both wheels on
the axle not being raised.
READ NEXT:
Wheel changing safety
Before raising the vehicle or changing a wheel,
ensure that you read and comply with the
following warnings.
Always find a safe place to
stop, off
the highway and away from traffic.
Ensure tha
Locking wheel nuts
Locking wheel nuts can be removed only by
using the special adapter provided in the tool
kit.
Note: When the vehicle is first supplied, the
adapter may be stored in the glove
compartment. It shou
Releasing locking wheel nuts
1. Insert the wheel nut adapter into the
locking wheel nut, ensuring that it is fully
engaged.
2. Locate the wheel brace over the adapter
and unscrew the wheel nut half a turn
counter clockwise.
SEE MORE:
Fuse box locations
Fuse box locations
When a fuse box lid is
removed, take
care to protect the box from moisture,
and refit the lid at the earliest
opportunity.
Engine compartment - fuse box access:
1. Remove the two plastic fixings.
2. Pull the tube up to release from the air box.
3. Delatch the tabs. Th
Inner Constant Velocity (CV) Joint Boot
Special Tool(s)
303-D121
Puller, General Purpose
General Equipment
Vise
Removal
NOTE: RH inner constant velocity joint boot shown, LH is similar.
1. Refer to: Rear Halfshaft LH (205-05 Rear Drive Halfshafts, Removal
and Installation).
Refer to: Rear Halfshaft RH (205-05 Rear Drive Halfshafts, Re
© 2011-2025 Copyright www.rrevoque.org
