Range Rover Evoque: Rain sensor/speed sensitive wiper control
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Wipers and washers / Rain sensor/speed sensitive wiper control
Intermittent operation of the wipers is controlled initially by either vehicle speed or a rain sensor located at the upper edge of the windscreen. Both methods of control will clear the screens adequately. Vehicle speed control is set by the user and control via a rain sensor is automatic.
This function can be
enabled/disabled
by your Dealer/Authorised Repairer.
READ NEXT:
Rain sensor
Ensure that the wipers are
switched off
before entering a car wash. If the rain
sensitive wipers operate during the car
washing process, damage may occur to
the wiper mechanism.
The rain senso
Speed sensitive wipers
If vehicle speed drops below 6km/h (3.7mph)
with the wipers operating in positions (2) or
(3), the wipers will switch to the next lowest
speed. When vehicle speed increases to over
6km/h (3.7mph),
Drip wipe
If the drip wipe function is configured, the
wipers will operate four seconds after a
wash/wipe cycle has finished, to clear any
remaining drips from the windscreen.
This function can be enabled
SEE MORE:
Blower Motor LHD AWD/LHD FWD
Special Tool(s)
412-140
Remover/Installer, Blower Motor
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
1. NOTE: The recirculation blend door must be closed in order for
Front Side Member Section
Removal
NOTES:
The front side member is manufactured from RP260 and DP600.
The front side member section is cut from the front side member and is
manufactured from RP260.
This procedure is written for the LH front side member section replacement, the
LH and RH front side member sections differ i
© 2011-2025 Copyright www.rrevoque.org
