Range Rover Evoque: Rear lamp bulbs

1. Remove the two fixings.

1. Remove the two fixings.

2. Direction indicator.

3. Reversing lamp

Turn the relevant bulb holder counter clockwise and pull to remove from the lamp unit. Grip the holder then press the bulb into the holder and turn counter clockwise to release the bulb. Pull the bulb up to remove.

READ NEXT:

 Rear fog lamp

Access to the rear fog lamp requires special tools and should be undertaken only by a qualified technician. If in doubt, consult your Land Rover Dealer/Authorised Repairer.

 Cleaning the exterior

Remove any heavy deposits of mud and dirt with a hose before washing the vehicle. Never aim a hose water jet directly at the engine air intake, heater air intakes, body seals or at any compone

 Using white spirit

Stubborn stains such as tar spots and grease may require the use of white spirt. After use, ensure the area is washed immediately with warm soapy water to remove all traces of the spirit.

SEE MORE:

 Tyre change

Valve stem seal, washer, nut, valve core and cap should be replaced at every tyre change. Valve stem seal, washer and nut must be replaced if valve retention nut is loosened. Sensor units and nuts must be refitted using correct torque figures and associated profile. Damage to the vehicle m

 Rear Bumper Mounting

Removal NOTE: The rear bumper mounting is manufactured from mild steel. 1. In this procedure, to make sure the vehicle is correctly aligned, it must be placed on an approved alignment jig. 2. The rear bumper mounting is replaced in conjunction with: Rear bumper cover Rear bumper Back panel 3.

© 2011-2025 Copyright www.rrevoque.org