Range Rover Evoque: Using cruise control

Using cruise control
1. Set target speed, or increase speed.
2. RES. Resume set speed.
3. CAN. Suspends cruise control operation
without erasing memorised speed.
4. Decrease set speed.
Note: Cruise control is not available when
using Hill Descent Control or when a Terrain
Response special program has been selected.
Note: Do not use cruise control when driving
off-road.
READ NEXT:
When setting the cruise
control to the
speed limit, it is important to remember
that it is possible for the vehicle speed
to increase when travelling downhill.
This may result in the vehicle sp
To reduce cruising speed, press and hold
control (4). Release the switch when the
desired speed is reached, the new speed will be
set and maintained.
The set speed can be decreased in steps of
2k
Suspend cruise control with a single press of
control (3).
To resume cruise control at the previous set
speed, press control (2).
RES (2) should be used only
if the
driver is aware of the set
SEE MORE:
Removal
NOTES:
It is necessary to remove the inner quarter panel to enable removal and
installation of the rear wheelhouse outer.
The rear wheelhouse outer is manufactured from mild steel.
This method describes the LH rear wheelhouse outer, the RH side is similar.
1. The rear wheelhouse outer is
Component Location
COMPONENT LOCATION (GTDI)
Refrigerant pressure sensor
Cabin humidity sensor (if fitted)
A/C (air conditioning) compressor
ECT (engine coolant temperature) sensor
Ambient air temperature sensor
Air intake stepper motor
Pollution sensor
Windshield distribution (defrost) st
© 2011-2025 Copyright www.rrevoque.org
