Range Rover Evoque: Diesel engined vehicles
Do not use RME (bio-diesel)
except in
the case of those proprietary diesel
fuels which contain a mix of up to 7%.
Land Rover vehicles can accept no
responsibility for damage caused by
using RME in concentrations greater
than 7%.
Use only high quality diesel fuel according to EN590 or equivalent.
The quality of diesel fuel is variable, depending on geographic location. Always use premium or the highest quality fuel available in your locality. High quality fuel ensures a longer life for your engine components. Lower grade fuel contains higher levels of sulphur, which is detrimental to engine components. If low quality fuel is used, light coloured smoke may be evident at the exhaust.
Prolonged use of additives is not recommended. Do not add paraffin or petrol to diesel fuels.
If you inadvertently fill
your vehicle with
petrol instead of diesel, do not attempt
to start the engine. Contact your Dealer/
Authorised Repairer immediately.
Land Rover can accept no responsibility
for any damage caused by running your
vehicle with petrol or vegetable oil in the
fuel tank.
READ NEXT:
Sulphur content
If your vehicle is fitted
with a Diesel
Particulate Filter (DPF) the maximum
Sulphur content must not exceed
0.005%. Using an incorrect fuel will
cause serious damage to the DPF.
The Sulphur c
Running out of fuel
Avoid running out of fuel.
If the vehicle does run out of fuel, a minimum
of 4 litres (0.9 gallons) will be required to
restart the engine. The vehicle will need to be
driven 1.6-5 km (1-3 miles)
Fuel filler flap
Take note of all warnings
and
instructions given on the label affixed
to the inside of the filler flap.
The fuel filler flap is located on the right-hand
side of the vehicle, at the rear.
1. I
SEE MORE:
Fuel Tank and Lines - Diagnosis and Testing
Principles of Operation
For a detailed description of the fuel tank and lines systems, refer to the
relevant Description and Operation section in the
workshop manual. REFER to: (310-01B Fuel Tank and Lines - GTDi 2.0L Petrol)
Inspection and Verification
WARNINGS:
Eye protection must be worn at all
Cooling Fan
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Cooling System
