Range Rover Evoque: Anti-Lock Control - Stability Assist
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Brake System / Anti-Lock Control - Stability Assist
Accelerometer
Removal
NOTES:
Removal steps in this procedure may contain installation details.
LHD illustration shown, RHD is similar.
Vehicles with automatic transmission
1. Refer to: Floor Console Upper Section (501-12 Instrument Panel and Console, Removal and Installation).
2. Torque: 9 Nm
Vehicles with manual transmission
3. Refer to: Floor Console (501-12 Instrument Panel and Console, Removal and Installation).
4.
5.
6. Torque: 9 Nm
Installation
1. To install, reverse the removal procedure.
2. If a new component has been installed, configure using Land Rover approved diagnostic equipment.
READ NEXT:
Power Steering AWD
Component Location
Steering gear
Rubber seal assembly
Heat shield
Overview
The vehicle is fitted with EPS (electric power steering), provided by a ZF
Servolectric steering gear unit with variab
SEE MORE:
Fuel Rail
Special Tool(s)
310-198
Installer, Teflon Seal
310-199
Re-shape Tool, Teflon Seal
Removal
CAUTION: Make sure that all openings are sealed. Use new blanking caps.
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. Disconnect the battery ground c
Starting System - GTDi 2.0L Petrol
Starting System - Component
Location
COMPONENT LOCATION
Solenoid
12V supply from battery
Solenoid power supply from Battery Junction Box (BJB)
Starter motor
Pinion gear
Starting System - Overview
OVERVIEW
The starter motor is rated as 1.3 kW and is a Denso conventional design with
the motor
© 2011-2025 Copyright www.rrevoque.org
