Range Rover Evoque: Before programming
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Garage door opener / Before programming
When programming a device
that may
require you to press and re-press the
hand-held transmitter (cycle), unplug
the device during the cycling process to
prevent possible motor failure.
For best results, fit a new battery to the hand-held transmitter of the garage door opener (or other device) before programming.
If your garage door opener receiver (located in the garage) is equipped with an antenna, ensure that the antenna is hanging straight down.
READ NEXT:
Programming
Programming
With the engine switched off;
1. Ensure that the ignition system is on.
2. Hold the signal emitting end of the original
garage door opener hand-held transmitter
50 to 150 mm (2 to 6
Rolling code device equipment programming
Note: The assistance of a second person, may
make the following steps quicker and easier.
Once the button has been pressed there are
only 30 seconds in which to complete Step 3.
1. At the garage d
Reprogramming a single garage door opener button
To programme a device to a previously
programmed button:
1. Press and hold the desired
pre-programmed HomeLink button for at
least 20 seconds, but no longer than 30
seconds, until the indicator l
SEE MORE:
Manual Transmission/Transaxle External Controls
Torque Specifications
External Controls -
Component Location
COMPONENT LOCATION
Shift cables
Gear knob
Selector lever assembly
Selector lever mounting plate
External Controls -
Overview
OVERVIEW
The manual transmission external controls comprise a selector lever and two
shift cables. The se
Seats - Diagnosis and Testing
Principle of Operation
For a detailed description of the seating systems and operation, refer to the
relevant Description and Operation section of
the workshop manual. REFER to: Seats (501-10 Seating, Description and
Operation).
Inspection and Verification
CAUTION: Diagnosis by substitution from a
© 2011-2025 Copyright www.rrevoque.org
