Range Rover Evoque: Dual view selection
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Dual view / Dual view selection
When the ignition is switched on or the audio unit is turned on after being turned off, single view mode will be the default view.
To select dual view, press the dual view hard key on the fascia surround. See 111, AUDIO/VIDEO CONTROLS.
Press again to display the dual view Options menu. From here, a change can be made to the viewing source or dual view can be cancelled.
If TV or a video format source were being viewed previously, the same source will be displayed.
READ NEXT:
Dual view control menu
Dual view control menu
1. Select to cancel dual view and revert to the
menu for the current video source (TV,
DVD).
Note: The preview screen will be
deactivated if the vehicle is moving.
2. Se
Dual view tv operation
If you would like to change the TV programme
while the vehicle is moving, there are two
methods available;
1. Press the dual view hardkey to display the
control menu.
Select an alternative channe
Dual view video operation
When the video programme begins play, a root
menu with information about the video
programme and its content will be displayed on
screen.
Note: Information and style may vary due to
differing vid
SEE MORE:
Transmission Control Module (TCM), Gear Shift Module (GSM)
TRANSMISSION CONTROL MODULE (TCM)
TCM
Neutral 'N' position
Park 'P' position
Position sensor/manual shaft
Electrical connector
The TCM is located on the top of the transmission casing and is connected on
the high speed CAN (controller area network)
bus to send and receive information to and
Rear Lamp Mounting Panel
Removal
NOTES:
The rear lamp mounting panel is manufactured from mild steel.
The section of the rear lamp mounting panel described within this procedure is
for the access for installation of the
inner back panel assembly.
The upper NVH component must be replaced when a complete panel is installed
© 2011-2025 Copyright www.rrevoque.org
