Range Rover Evoque: Front/Rear Door Latch
Front Door Latch
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is always correct.
Make sure the door window glass is in the fully closed position.
1. Refer to: Exterior Front Door Handle (501-14 Handles, Locks, Latches and Entry Systems, Removal and Installation).
2.
3. Torque: 1 2 Nm
4. NOTE: Loosen the bolt, but do not fully remove.
Torque: 3.2 Nm
5. Torque: 7 Nm
6. CAUTION: Take extra care not to damage the component.
7. NOTE: Do not disassemble further if the component is removed for access only.
8.
Installation
1. To install, reverse the removal procedure.
Rear Door Latch
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is always correct.
1. Refer to: Exterior Rear Door Handle (501-14 Handles, Locks, Latches and Entry Systems, Removal and Installation).
2.
3. Torque: 1.2 Nm
4. NOTE: Loosen the bolt, but do not fully remove.
Torque: 3.2 Nm
5. Torque: 7 Nm
6. CAUTION: Take extra care not to damage the component.
7. NOTE: Do not disassemble further if the component is removed for access only.
8.
Installation
1. To install, reverse the removal procedure.
Liftgate Latch
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2. Torque: 25 Nm
3. Torque: 25 Nm
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Exterior Front/Rear Door Handle
Exterior Front Door Handle
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always co
Wipers and Washers - Component Location, System Operation and Component
Description
Component Location
COMPONENT LOCATION - SHEET 1 OF 2
Central Junction Box (CJB)
Integrated Control Panel (ICP)
Rain/Light sensor (if fitted)
Right tailgate actuator (upper)
Rear wiper motor
Le
SEE MORE:
Engine Cooling - Diagnosis and Testing
Principles of Operation
For a detailed description of the cooling system, refer to the relevant
Description and Operation section in the workshop
manual. REFER to: (303-03B Engine Cooling - GTDi 2.0L Petrol)
Inspection and Verification
CAUTION: Diagnosis by substitution from a donor vehicle is NOT
Body Repairs - Corrosion Protection
Corrosion Protection
Galvanic Corrosion
Galvanic corrosion is the cross-contamination of dissimilar metals, in this
case aluminium and steel. Avoidance of galvanic
corrosion is an important issue to be considered in the repair of aluminium
bodied vehicles.
Precautions to prevent the contamination
