Range Rover Evoque: Anti-Lock Control - Stability Assist
Accelerometer
Removal
NOTES:
Removal steps in this procedure may contain installation details.
LHD illustration shown, RHD is similar.
Vehicles with automatic transmission
1. Refer to: Floor Console Upper Section (501-12 Instrument Panel and
Console, Removal and Installation).
2. Torque: 9 Nm

Vehicles with manual transmission
3. Refer to: Floor Console (501-12 Instrument Panel and Console,
Removal and Installation).
4.

5.

6. Torque: 9 Nm

Installation
1. To install, reverse the removal procedure.
2. If a new component has been installed, configure using Land Rover
approved diagnostic equipment.
READ NEXT:
Component Location
Steering gear
Rubber seal assembly
Heat shield
Overview
The vehicle is fitted with EPS (electric power steering), provided by a ZF
Servolectric steering gear unit with variab
SEE MORE:
Component Location
Steering gear
Rubber seal assembly
Heat shield
Overview
The vehicle is fitted with EPS (electric power steering), provided by a ZF
Servolectric steering gear unit with variable
ratio, rack and pinion steering and speed sensitive power assistance. Power
assistance is from a
When setting the cruise
control to the
speed limit, it is important to remember
that it is possible for the vehicle speed
to increase when travelling downhill.
This may result in the vehicle speed
exceeding the speed limit.
Note: Cruise control can be engaged only at
speeds in excess of 30
© 2011-2025 Copyright www.rrevoque.org
