Range Rover Evoque: C-Pillar Upper Trim Panel

Removal

NOTE: Removal steps in this procedure may contain installation details.

1.

Range Rover Evoque. Interior Trim and Ornamentation

2.

Range Rover Evoque. Interior Trim and Ornamentation

3.

Range Rover Evoque. Interior Trim and Ornamentation

4.

Range Rover Evoque. Interior Trim and Ornamentation

5. Torque: 6 Nm

Range Rover Evoque. Interior Trim and Ornamentation

6.

Range Rover Evoque. Interior Trim and Ornamentation

Installation

1. To install, reverse the removal procedure.

C-Pillar Lower Trim Panel

Removal

1. Refer to: Rear Seat Cushion (501-10 Seating, Removal and Installation).

2. Refer to: Loadspace Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).

3.

Range Rover Evoque. Interior Trim and Ornamentation

4.

Range Rover Evoque. Interior Trim and Ornamentation

5.

Range Rover Evoque. Interior Trim and Ornamentation

Installation

1. To install, reverse the removal procedure.

READ NEXT:

 Rear Quarter Trim Panel

Removal NOTE: Removal steps in this procedure may contain installation details. 1. Refer to: Rear Seat Cushion (501-10 Seating, Removal and Installation). 2. Refer to: Loadspace Trim Panel (501-05 Int

 Exterior Trim and Ornamentation

Torque Specifications Rear Quarter Panel Moulding Removal NOTE: Removal steps in this procedure may contain installation details. 1. 2. NOTE: Discard the retaining clips. Make sure that the centre

 Rear View Mirrors

Rear View Mirrors - Component Location NOTE: RHD (right-hand drive) installation shown, LHD (left-hand drive) installation similar. DDM (driver door module) Driver exterior mirror Exterior mirro

SEE MORE:

 Service interval indicator

The service interval message will only be displayed when the vehicle has less than 3200 km (2000 miles) before the service is due. When the ignition is switched on, and the vehicle has started its service countdown, SERVICE REQ'D XXXX km (XXXX MLS) / XX DAYS is displayed in the message centre

 Transmission Vehicles With: M66 6-Speed Manual Transmission FWD - Installation

Installation Special Tool(s) 303-021 Engine support bracket 303-662 Support Beam Arm and Hook Assembly, Engine NOTE: Some variation in the illustrations may occur, but the essential information is always correct. 1. NOTE: This step is only required if previously removed. 2. NOTE: This step is only

© 2011-2025 Copyright www.rrevoque.org