Range Rover Evoque: Fuse box locations
Fuse box locations
When a fuse box lid is
removed, take
care to protect the box from moisture,
and refit the lid at the earliest
opportunity.
Engine compartment - fuse box access: 1. Remove the two plastic fixings.
2. Pull the tube up to release from the air box.
3. Delatch the tabs. The fuse box can now be opened.
The engine compartment fuse numbers and positions are shown on the inside of the fuse box cover.
Passenger compartment - fuse box access.
There are two covers.
4. To access the upper part, open the glovebox and remove the panel from the glovebox liner. A label on the panel shows the circuits protected and the fuse locations.
5. To access the lower part, remove the lower access panel.
Luggage compartment - fuse box access: 6. Remove the panel from the left side trim of the luggage compartment.
READ NEXT:
Changing a fuse
Always turn off the ignition
system and
the affected electrical circuit, before
replacing a fuse.
Fit Land Rover approved replacement
fuses of the same rating and type, or
fuses of matching sp
SEE MORE:
Rear Side Member Lower Side Extension
Removal
NOTE: The rear side member lower side extension is manufactured from mild
steel.
1. The rear side member lower side extension is replaced in
conjunction with:
Rear bumper cover
Rear bumper
Rear lamp mounting panel
2. For additional information relating to this repair procedure please
Single locking
Single locking secures the vehicle and prevents
the doors from being opened from outside. The
doors may still be unlocked and opened using
the interior door locks and release levers. In
this state, only the perimeter (exterior) alarm is
activated. When the vehicle is Single locked
and the alar
