Range Rover Evoque manuals

Range Rover Evoque: Oil Cooler

Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Engine / Engine - GTDi 2.0L Petrol / Oil Cooler

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

2. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

3. Refer to: Cooling System Partial Draining, Filling and Bleeding (303-03B Engine Cooling - GTDi 2.0L Petrol, General Procedures).

4. Refer to: Engine Oil Draining and Filling (303-01B Engine - GTDi 2.0L Petrol, General Procedures).

5. Refer to: Engine Cover - GTDi 2 0L Petrol (501-05 Interior Trim and Ornamentation, Removal and Installation).

6.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

7. CAUTION: Make sure that the area around the component is clean and free of foreign material.

READ NEXT:

 Oil Pan

Removal NOTES: Some illustrations may show the engine removed for clarity. Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this proc

 Oil Pump

Removal NOTES: Some illustrations may show the engine removed for clarity. Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this proc

 Timing Chain

Removal NOTES: Some illustrations may show the engine removed for clarity. Some variation in the illustrations may occur, but the essential information is always correct. 1. Refer to: Specifications

SEE MORE:

 Wipers and Washers - Removal and Installation

Windshield Wiper Motor Removal NOTE: Removal steps in this procedure may contain installation details. 1. Refer to: Plenum Chamber (412-01 Climate Control, Removal and Installation). 2. NOTE: LHD illustration shown, RHD is similar. Torque: 8 Nm Installation 1. To install, reverse the removal proced

 Generator and Regulator - GTDi 2.0L Petrol

Generator - Component Location COMPONENT LOCATION Battery positive connection LIN (local interconnect network) bus connection Generator Generator - Overview OVERVIEW A single self-exciting generator is located at the front of the engine on the LH (left-hand) side of the cylinder block. There

© 2011-2025 Copyright www.rrevoque.org