Range Rover Evoque: Powered tailgate opening height

The maximum opening height can be set as required. This is useful in parking areas with low ceiling heights or just for ease of use.

1. Open the tailgate to the position which you want to set as the maximum height. Press any tailgate control to stop movement at the required position. Final position can be achieved manually if required.

2. Ensure that the tailgate is stationary for at least three seconds.

3. Press and hold the tailgate close switch for ten seconds to set the maximum opening height.

4. Close the tailgate, then open again to check that it opens to the programmed height.

Note: If, after performing part 3 of the process the tailgate closes automatically, the required height has not been set. Repeat the process ensuring that all steps are adhered to.

To reset the maximum opening height, repeat the process, but when the tailgate reaches its current programmed height, manually move it to the fully open position before pressing and holding the button.

READ NEXT:

 Programmed position loss

The powered tailgate may lose its position memory if there are multiple object detections or if battery voltage is low. Powered operation may be inhibited. To reset the tailgate; 1. Manually close

 Changing the smart key batttery

When the battery needs renewing, there will be a significant decrease in the effective range and the message SMART KEY BATTERY LOW will be displayed in the message centre. To renew the battery:

 Exiting the vehicle

SEE MORE:

 Shock Absorber and Spring Assembly Vehicles Without: Dynamic Suspension

Special Tool(s) 205-754A Splitter, Ball Joints 205-857 Remover, Halfshaft JLR-204-804 Lever, Wheel Knuckle General Equipment Transmission jack Wooden Block Removal CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. NOTE: Some variation in the illustrati

 Opening and closing the bonnet

Opening and closing the bonnet Opening 1. Pull the bonnet release lever, located in the left-hand front footwell. 2. Lift the bonnet safety catch lever, located below the centre point of the bonnet, then raise the bonnet. Closing Do not drive with the bonnet retained by the safety catc

© 2011-2025 Copyright www.rrevoque.org