Range Rover Evoque: Speed Control

Range Rover Evoque. Speed Control

Speed Control Actuator

Removal

1. Refer to: Accelerator Pedal (310-02 Acceleration Control, Removal and Installation).

Installation

1. To install, reverse the removal procedure.

Speed Control Deactivator Switch

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. CAUTION: LH illustration shown, RH is similar.

Range Rover Evoque. Speed Control

2.

Range Rover Evoque. Speed Control

Installation

1. To install, reverse the removal procedure.

Speed Control Switch

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Make the air bag supplemental restraint system (SRS) safe.

Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation).

2. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

3. Refer to: Driver Air Bag Module (501-20B Supplemental Restraint System, Removal and Installation).

4. Torque: 1.3 Nm

Range Rover Evoque. Speed Control

5. CAUTION: Take extra care not to damage the edges of the component.

Torque: 2.1 Nm

Range Rover Evoque. Speed Control

6. NOTE: Do not disassemble further if the component is removed for access only.

Range Rover Evoque. Speed Control

Installation

1. To install, reverse the removal procedure.

READ NEXT:

 Climate Control System

 Climate Control System - General Information

Climate Control Lubricants, Fluids, Sealers and Adhesives General Specification Capacities Refrigerant oil adding capacities for replacment parts NOTE: Rotate the A/C compressor shaft at least 6 t

 Climate Control

SEE MORE:

 Exterior Front/Rear Door Handle

Exterior Front Door Handle Removal NOTES: Removal steps in this procedure may contain installation details. Some variation in the illustrations may occur, but the essential information is always correct. Make sure the door window glass is in the fully closed position. 1. Refer to: Front Door Tri

 Pairing and connecting from your mobile phone

Note: The process of pairing and connecting your phone with the vehicle using the mobile phone, will vary depending on the type of mobile phone used. 1. Switch the ignition on and ensure that the touch screen is active. 2. From the home menu, select Phone. 3. A menu will appear. Select Search

© 2011-2025 Copyright www.rrevoque.org